Re: Problems with ATLOD after reference frame changes in AIPS
- Contemporary messages sorted: [ by date ] [ by thread ] [ by subject ] [ by author ] [ by messages with attachments ]
From: <adeller_at_email.protected>
Date: Tue, 8 Dec 2009 11:22:30 -0700
Hi all,
I just spoke to Eric and he is aware of the problem and taking a look
in debug mode now. Apparently he didn't get Simon's first email and
only just found out about the problem a couple of minutes ago. But I
suspect he will be able to locate the cause.
Cheers,
Adam
On Tue, Dec 8, 2009 at 3:50 AM, Chris Phillips <Chris.Phillips_at_csiro.<!--nospam-->au> wrote:
>There are definitely differences - Eric made a number of changes to get it
>to work with intel compiler etc. But this is good, as it probably means he
>will fix the problem.
>
>Cheers
>Chris
>
>------------------------------------------------------------
>Chris Phillips
>CSIRO ATNF eVLBI project scientist
>Office: (+61) (0)2 93724608 Mobile: (+61) (0)439487601
>
>
>
>On 08/12/2009, at 9:49 PM, Simon Ellingsen wrote:
>
>>Hi Chris,
>>
>>>Is this using the "NRAO" version of ATLOD or the ATNF version???
>>
>>This is a standard NRAO 31DEC09 installation, which includes ATLOD
>>5.3k in the distribution (I looked in ATLOD.FOR). As far as I can
>>tell 5.3k is the latest version of ATLOD present on the ATNF website.
>>So I don't think there is any difference.
>>
>>>
>>>Cheers
>>>Chris
>>>________________________________________
>>>From: owner-vlbiobs_at_atnf.<!--nospam-->csiro.au [owner-vlbiobs_at_atnf.<!--nospam-->csiro.au] On
>>>Behalf Of Simon Ellingsen [Simon.Ellingsen_at_utas.<!--nospam-->edu.au]
>>>Sent: Tuesday, 8 December 2009 7:51 PM
>>>To: VLBI observers
>>>Cc: brunthal_at_mpifr-bonn.<!--nospam-->mpg.de
>>>Subject: Problems with ATLOD after reference frame changes in AIPS
>>>
>>>Dear LBAers,
>>>
>>>Most of you would have seen the emails from Eric Greisen and Craig
>>>Walker about the changes in the AN table format and geometry
>>>introduced into AIPS a month or two back. After running the midnight
>>>job on my 31DEC09 distribution late last week I found that I could no
>>>longer load LBA data into AIPS using ATLOD (it crashes as shown
>>>below). I was able to rollback my AIPS distribution a few weeks to
>>>prior to the reference frame changes and ATLOD now works again as
>>>expected.
>>>
>>>I have emailed Eric Greisen to inform him of the problem, but have not
>>>yet had a response.
>>>
>>>The basic message at the moment though is you can't use ATLOD with
>>>versions of AIPS which have changed to the right-handed terrestrial
>>>reference frame.
>>>
>>>elling> ATLOD1: Task ATLOD (release of 31DEC09) begins
>>>elling> ATLOD1: Using compressed uv data format.
>>>elling> ATLOD1: Dropping all flagged visibilities.
>>>elling> ATLOD1: Retaining autocorrelations.
>>>elling> ATLOD1: Vis weights set to integration time in units of 15 sec
>>>elling> ATLOD1: Averaging all pulsar bins
>>>elling> ATLOD1:
>>>elling> ATLOD1: Processing file: 1
>>>elling> ATLOD1: Input polarizations: RR,LL
>>>elling> ATLOD1:
>>>elling> ATLOD1: Create T09149ALL .UVDATA. 1 (UV) on disk 1
>>>cno 25
>>>elling> ATLOD1: Recomputing UVWs for pre-20/02/1998 LBA data
>>>elling> ATLOD1:
>>>elling> ATLOD1: File: 1, Scan: 1
>>>elling> ATLOD1: ZABORS: signal 10 received
>>>elling> ATLOD1: ABORT!
>>>
>>>Regards
>>>
>>>Simon
>>>--
>>>Simon Ellingsen : Senior Lecturer Physics & Astronomy, University of
>>>Tasmania
>>>Currently : Humboldt Experienced Research Fellow, MPIfR, Bonn
>>>email : Simon.Ellingsen_at_utas.<!--nospam-->edu.au
>>>WWW :
>>>http://fcms.its.utas.edu.au/scieng/physics/pagedetails.asp?lpersonId=681
>>>Phone : +49 (0)228 525 392 (work) +49 (0)1522 374 5728 (mobile)
>>>
>>>
>>>
>>
>>Regards
>>
>>Simon
>>--
>>Simon Ellingsen : Senior Lecturer Physics & Astronomy, University of
>>Tasmania
>>Currently : Humboldt Experienced Research Fellow, MPIfR, Bonn
>>email : Simon.Ellingsen_at_utas.<!--nospam-->edu.au
>>WWW :
>>http://fcms.its.utas.edu.au/scieng/physics/pagedetails.asp?lpersonId=681
>>Phone : +49 (0)228 525 392 (work) +49 (0)1522 374 5728 (mobile)
>>
>>
>>
>
>
Date: Tue, 8 Dec 2009 11:22:30 -0700
Hi all,
I just spoke to Eric and he is aware of the problem and taking a look
in debug mode now. Apparently he didn't get Simon's first email and
only just found out about the problem a couple of minutes ago. But I
suspect he will be able to locate the cause.
Cheers,
Adam
On Tue, Dec 8, 2009 at 3:50 AM, Chris Phillips <Chris.Phillips_at_csiro.<!--nospam-->au> wrote:
>There are definitely differences - Eric made a number of changes to get it
>to work with intel compiler etc. But this is good, as it probably means he
>will fix the problem.
>
>Cheers
>Chris
>
>------------------------------------------------------------
>Chris Phillips
>CSIRO ATNF eVLBI project scientist
>Office: (+61) (0)2 93724608 Mobile: (+61) (0)439487601
>
>
>
>On 08/12/2009, at 9:49 PM, Simon Ellingsen wrote:
>
>>Hi Chris,
>>
>>>Is this using the "NRAO" version of ATLOD or the ATNF version???
>>
>>This is a standard NRAO 31DEC09 installation, which includes ATLOD
>>5.3k in the distribution (I looked in ATLOD.FOR). As far as I can
>>tell 5.3k is the latest version of ATLOD present on the ATNF website.
>>So I don't think there is any difference.
>>
>>>
>>>Cheers
>>>Chris
>>>________________________________________
>>>From: owner-vlbiobs_at_atnf.<!--nospam-->csiro.au [owner-vlbiobs_at_atnf.<!--nospam-->csiro.au] On
>>>Behalf Of Simon Ellingsen [Simon.Ellingsen_at_utas.<!--nospam-->edu.au]
>>>Sent: Tuesday, 8 December 2009 7:51 PM
>>>To: VLBI observers
>>>Cc: brunthal_at_mpifr-bonn.<!--nospam-->mpg.de
>>>Subject: Problems with ATLOD after reference frame changes in AIPS
>>>
>>>Dear LBAers,
>>>
>>>Most of you would have seen the emails from Eric Greisen and Craig
>>>Walker about the changes in the AN table format and geometry
>>>introduced into AIPS a month or two back. After running the midnight
>>>job on my 31DEC09 distribution late last week I found that I could no
>>>longer load LBA data into AIPS using ATLOD (it crashes as shown
>>>below). I was able to rollback my AIPS distribution a few weeks to
>>>prior to the reference frame changes and ATLOD now works again as
>>>expected.
>>>
>>>I have emailed Eric Greisen to inform him of the problem, but have not
>>>yet had a response.
>>>
>>>The basic message at the moment though is you can't use ATLOD with
>>>versions of AIPS which have changed to the right-handed terrestrial
>>>reference frame.
>>>
>>>elling> ATLOD1: Task ATLOD (release of 31DEC09) begins
>>>elling> ATLOD1: Using compressed uv data format.
>>>elling> ATLOD1: Dropping all flagged visibilities.
>>>elling> ATLOD1: Retaining autocorrelations.
>>>elling> ATLOD1: Vis weights set to integration time in units of 15 sec
>>>elling> ATLOD1: Averaging all pulsar bins
>>>elling> ATLOD1:
>>>elling> ATLOD1: Processing file: 1
>>>elling> ATLOD1: Input polarizations: RR,LL
>>>elling> ATLOD1:
>>>elling> ATLOD1: Create T09149ALL .UVDATA. 1 (UV) on disk 1
>>>cno 25
>>>elling> ATLOD1: Recomputing UVWs for pre-20/02/1998 LBA data
>>>elling> ATLOD1:
>>>elling> ATLOD1: File: 1, Scan: 1
>>>elling> ATLOD1: ZABORS: signal 10 received
>>>elling> ATLOD1: ABORT!
>>>
>>>Regards
>>>
>>>Simon
>>>--
>>>Simon Ellingsen : Senior Lecturer Physics & Astronomy, University of
>>>Tasmania
>>>Currently : Humboldt Experienced Research Fellow, MPIfR, Bonn
>>>email : Simon.Ellingsen_at_utas.<!--nospam-->edu.au
>>>WWW :
>>>http://fcms.its.utas.edu.au/scieng/physics/pagedetails.asp?lpersonId=681
>>>Phone : +49 (0)228 525 392 (work) +49 (0)1522 374 5728 (mobile)
>>>
>>>
>>>
>>
>>Regards
>>
>>Simon
>>--
>>Simon Ellingsen : Senior Lecturer Physics & Astronomy, University of
>>Tasmania
>>Currently : Humboldt Experienced Research Fellow, MPIfR, Bonn
>>email : Simon.Ellingsen_at_utas.<!--nospam-->edu.au
>>WWW :
>>http://fcms.its.utas.edu.au/scieng/physics/pagedetails.asp?lpersonId=681
>>Phone : +49 (0)228 525 392 (work) +49 (0)1522 374 5728 (mobile)
>>
>>
>>
>
>
-- !=============================================================! Dr. Adam Deller Ph +1 575 835 7492 Jansky Fellow Fax +1 575 835 7027 National Radio Astronomy Observatory Socorro NM 87801, USA !=============================================================!Received on 2009-12-09 05:22:56