Документ взят из кэша поисковой машины. Адрес оригинального документа : http://www.atnf.csiro.au/pub/people/vlbi/v180/v180a/vt002b2.sum Дата изменения: Sun Mar 13 07:58:26 2005 Дата индексирования: Wed Dec 26 18:12:02 2007 Кодировка: Поисковые слова: http astrokuban.info astrokuban

SUMMARY FILE FOR PROJECT: vt002b2

COVER INFORMATION:

Experiment: v180a fringe test
Exp. Code: vt002b2
Start Day 72 is Sun 13 Mar 2005 MJD 53442

Schedule Version: 1.00
Processed by SCHED version: Release of 18 Sept. 2003

PI: Steven Tingay

Address: Swinburne University of Technology
Mail number 31
P.O. Box 218, Hawthorn, Victoria 3122, Australia


Phone: +61-03-92148758
EMAIL: stingay@astro.swin.edu.au
Fax: +61-03-92148797
Phone during observation:

Observing mode: LBA, 2.3 GHz continuum, 128-2-2

Notes:
Fringe finders: 1253-055




No cover letter provided.

CORRELATION REQUESTS (Defaults in parentheses):

Correlator (Required if recording): LBA
Correlator average time (2 sec): 2.000 sec.
Alternate average time (for spacecraft). 0.000 sec.
Spectral channels per baseband (16): 32
Number of antennas to be correlated: 5
Polarization (ON): OFF
Correlator weighting function (UNIFORM): UNIFORM
Distribution tape (DAT): DAT
Source positions from: STANDARD


Shipping address for correlator output:
Steven Tingay
Swinburne
Hawthorn, Victoria, Australia


Correlator Notes:







DERIVED INFORMATION FOR CORRELATION:

Elapsed time for project: 3.00 hours.
Total time in scheduled scans: 3.00 hours.
Total time in recording scans: 3.00 hours.
Total number of baseline hours: 30.00 (Recording scans only)
Projected maximum data output rate from the correlator: 0.0 kbytes/sec
if processed in one pass.
Projected correlator output data set size: 0.0 Mbytes
NOTE: Above numbers assume the same correlator parameters are used for all data.



STATIONS USED IN SCHEDULE:

Station Code Latitude Longitude Elevation X Y Z

ATCA At -30.31000-149.57000 217. -4752008.07 2791332.20 -3200197.64
MOPRA Mp -31.30000-149.07000 840. -4679708.39 2804076.69 -3294795.70
PARKES Pa -32.99840-148.26351 415. -4554232.11 2816759.14 -3454036.01
HOBART Ho -42.80359-147.44052 65. -3950236.75 2522347.55 -4311562.55



BASELINE LENGTHS (km)

At Mp Pa Ho

At 0 119 322 1396
Mp 119 0 203 1282
Pa 322 203 0 1089
Ho 1396 1282 1089 0


RECORDING SYSTEM INFORMATION:

TAPES - Stations potentially recording on tape.
(See setup details later for times per pass.)
Station Drives Head pos Tape len Density Start position Auto Auto Recorder
(ft) Driv Head indx Aloc Reverse
ATCA 8 1 7600 High 1 1 No No S2
MOPRA 8 1 7600 High 1 1 No No S2
PARKES 8 1 7600 High 1 1 No No S2
HOBART 8 1 7600 High 1 1 No No S2




EXPERIMENT SUMMARY:
Number of input scans: 3
Number of scans scheduled: 3
Number of stations: 4
Number of sources input: 1
Number of setup files used: 1

Station summaries (tape stations):
Station Control Scans Scan Hours Tape hours Tapes Passes Readbacks
ATCA VEX 3 3.00 3.00 1 1 0
MOPRA VEX 3 3.00 3.00 1 1 0
PARKES VEX 3 3.00 3.00 1 1 0
HOBART VEX 3 3.00 3.00 1 1 0

Station summaries (disk stations):
Station Control Scans Scan Hours Record hrs Gbytes





Setup file: lba6cm-1p-2IF.set
Matches group at6cm in /nfs/atapplic/vlbi/sched/catalogs/freq.dat

Setup group: 1 Station: ATCA Total bit rate: 128
Format: S2 Bits per sample: 2 Sample rate: 32.000
Number of channels: 2 Passes/head pos: 1 Speedup factor: 1.00

Tape speeds: Low density - 6.300 ips, High density - 4.20 ips
Time per pass for 7600 ft, High density tapes is: 06:01:54

1st LO= 4500.00 4500.00
Net SB= U U
Pol. = RCP RCP
BBC = 1 3
BBC SB= U U
IF = A A

The following frequency sets based on this setup were used.

Frequency Set: 1 Setup file default. No pcal detection.
LO sum= 4800.00 4816.00
BBC fr= 300.00 316.00
Bandwd= 16.000 16.000

Track assignments are:
track1= 0, 0
barrel=roll_off


Setup file: lba6cm-1p-2IF.set
Matches group mp6cm in /nfs/atapplic/vlbi/sched/catalogs/freq.dat

Setup group: 2 Station: MOPRA Total bit rate: 128
Format: S2 Bits per sample: 2 Sample rate: 32.000
Number of channels: 2 Passes/head pos: 1 Speedup factor: 1.00

Tape speeds: Low density - 6.300 ips, High density - 4.20 ips
Time per pass for 7600 ft, High density tapes is: 06:01:54

1st LO= 4500.00 4500.00
Net SB= U U
Pol. = RCP RCP
BBC = 1 3
BBC SB= U U
IF = A A

The following frequency sets based on this setup were used.

Frequency Set: 2 Setup file default. No pcal detection.
LO sum= 4800.00 4816.00
BBC fr= 300.00 316.00
Bandwd= 16.000 16.000

Track assignments are:
track1= 0, 0
barrel=roll_off


Setup file: lba6cm-1p-2IF.set
Matches group pa6cm in /nfs/atapplic/vlbi/sched/catalogs/freq.dat

Setup group: 3 Station: PARKES Total bit rate: 128
Format: S2 Bits per sample: 2 Sample rate: 32.000
Number of channels: 2 Passes/head pos: 1 Speedup factor: 1.00

Tape speeds: Low density - 6.300 ips, High density - 4.20 ips
Time per pass for 7600 ft, High density tapes is: 06:01:54

1st LO= 4500.00 4500.00
Net SB= U U
Pol. = RCP RCP
BBC = 1 3
BBC SB= U U
IF = A A

The following frequency sets based on this setup were used.

Fr