Документ взят из кэша поисковой машины. Адрес оригинального документа : http://www.naic.edu/alfa/galfa/docs/galspect/motorolacpu/CPUsetup.pdf Дата изменения: Sat Aug 21 04:24:27 2004 Дата индексирования: Sun Dec 23 05:39:34 2007 Кодировка: Поисковые слова: http astrokuban.info astrokuban

Setting up a Motorola CPV5350 cPCI CPU Board for Operation with the GALFA/SERENDIP5 Spectrometer
Loading the OS onto the onboard hard drive for the first time: 1. Turn on CPU 2. Press F2 to enter BIOS setup 3. Under Exit menu a. Reset to default BIOS settings (F9) b. Save changes 4. Under Advanced PCI Configuration a. Enable On-Card Ethernet 1 b. Enable ROM option for On-Card Ethernet 1 c. Disable On-Card Ethernet 2 5. Under Boot Boot Device Priority a. Disable all but Ethernet 1 6. Save changes and exit 7. Connect both CPU board and boot server to hub 8. Reboot the CPU board and allow it to boot from the boot server 9. Copy the OS to the hard drive: makedisk ­s6 ­d /dev/hda 10. Reboot CPU board; press F2 to re-enter BIOS setup 11. Under Boot Boot Device Priority a. Disable all but hard drive 12. Reboot the CPU board NOTE: At least one board has Ethernet ports 1 and 2 wired back to front. Configuring CPU board for network interface: 1. Set IP addresses: 2. 3. 4. Add DNS servers in /etc/resolv.conf:
ifconfig eth0 xxx.xxx.xxx.xxx netmask xxx.xxx.xxx.xxx broadcast xxx.xxx.xxx.xxx Add default gateway: route add default gw xxx.xxx.xxx.xxx Check settings: netstat ­nr nameserver xxx.xxx.xxx.xxx