... The rotator's outer ring without paint, then a similar section painted, and then the outer ring ready for shipment. ... The inner ring's flange mounting tab for attaching to the outer ring (lower edge of ring). ...
... Ring 1 is the ring nearest the secondary. Ring 5 is the secondary baffle tip. ... Ring 1 was measured to be out of plane by 1.04 mm p-v. Forcing this ring co-planar ...
... 101206 : M57 - Ring Nebula; Jack Dembicky, Apache Point observer . ... 062603 : M57 - Ring Nebula (comparison) . 013100 : M67 - Old Open Cluster; Xiaou-Hui Fan, Princeton University . ...
... Here the ring seal is removed. The ring is raised and the bearing exposed. Close-up of the bearings. ... Here the ring seal is removed. The ring is raised and the bearing exposed. Close-up of the bearings. ...
... Once all bolts are loosened, remove the bending ring from the cartridge; the ring weighs approximately 20 lbs. ... Do not lay the bending ring down flat; use the storage jig to hold the ring. ...
... consists of plug-plate clamping rings, 32 fiber harnesses each containing 20 fibers ... The plug-plate is clamped between two bending rings. ... The bevelled edge of one ring is visible above the plug-plate. ...
... If the common corrector ring is mounted, you will also need: . ... before mounting the common corrector mounting ring (and thus before mounting the ... Continue with the rest of this procedure, directly measuring the position of M1. ...
... Bump caps are desired when working on top of the azimuth drive ring. ... Loosen horizontal foot the remaining amount , push preload foot in to ring and work drive box away from disc. ...