Next Previous Contents . This means that an interrupt happened that no driver expected. ... In many cases you can safely ignore this error message, especially if it only happens once or twice at boot-time. For boot-time messages, look at the messages which are nearby for a clue as to what is going on. For example, if probing is going on, perhaps a probe for a physical device caused that device to issue an interrupt that the driver didn't expect. ...

. GTK+ 2.0 Tutorial . Prev . Chapter 12. Undocumented Widgets . Next . Prev . Home . Next . Font Selection Dialog . Up . Gamma Curve

... About half an hour after the BAT trigger, the first images were obtained with the SAO RAS Zeiss-1000 telescope in four BVRI filters (see Fig.1). ... The spectrum of the optical transient was obtained with the SAO RAS 6-m BTA telescope 1.54 hours after the burst, using the SCORPIO instrument in the spectroscopic mode (Fig.2). ... The spectrum of the optical transient GRB090726 with identified lines, obtained with the BTA 1.54 hours after the burst. ...

... Corresponding gates in each row are connected in parallel at both edges of the array. ... Other gates. ... otherwise indicated, 45 kpixels/sec and standard voltages using a dual slope CDS circuit (8 µs integration time) Minimum Format Pixel Size Imaging Area Dark current (MPP), 20° C equivalent Readout noise Front Back Full Well signal Output gain CTE per pixel Typical 512 x 512 pixels 24 µm x 24 µm 12.3 mm x 12.3 mm 50 pa/cm2 5 electrons 7 electrons 350,000 electrons 1.5 µV/ electron 0 ...