... true false . A boolean switch determining whether the list of to be considered HK parameters shall be explicitly specified with parameter parameters . ... blank separated list of HK parameter names . ... If set to true overrideparameters must contain a list of HK parameter names and overrideparametervalues a corresponding list of validity ranges for those parameters (see below). overrideparameters . ... If withoverrideparameters is set to true the list must contain valid HK parameter names. ...

HI line flux (flux corresponding to the area under the 21-cm line profile) is generally expressed in converted in magnitude m21 according to the formula adopted in RC3: m21 = -2.5 log f + 17.40 where f is the area of the 21-cm line profile expressed in Jy*km/s (the constant is 16.6 if the flux is in 10**-22 W/m**2). Non-detections (or upper limits) are not stored in the database, therefore galaxies with no HI measurements available may either be too faint or not have been observed. ... HyperLeda . ...

Next: Program use Up: Description of program searchdup Previous: Description of program searchdup . Parameter input is done with a graphic user interface. ... Input file: Name of the input catalog file. It has to be formatted, one record per source/observation, according to the format used in the Arcetri observations and source archives. ... Minimum number of observations per source Source with less than this number of independent observations are not included in the output file . ...

... User Guide ] Task: imdiff Purpose: Shift and expand an image to make it match another. ... No default. Key: in2 The second input image. ... Key: adjust This gives the name of an output image data-set, being a version of second image after adjustment. ... The following five parameters give the initial estimates for the various parameters that IMDIFF is trying to find. ... Key: expand This gives the initial expansion. ... Key: offset This gives the initial dc offset to apply to IN2. ...

... Basic Observables: Zero-differenced phase and code ionosphere-free combinations of global GNSS network stations, corrected by P1-C1 satellite code biases (cc2noncc), daily observations with 30 seconds sampling rate Sites coordinates : IGb08 reference frame coordinates and velocities Displacements: solid tides, ocean loading, pole tide loading (IERS 2010) Geometric model : Receivers antennas eccentricities, absolute receiver and ...

Next: Parameters of the starburst Up: The Model Previous: Initial parameters of compact . ... If the rate of accretion from one star to another is sufficiently high (e.g., the mass transfer occurs on a timescale a few times shorter than the thermal Kelvin-Helmholz time for the normal companion) or the compact object is engulfed by a giant companion, the common envelope (CE) stage of the binary evolution can set in (see Paczynski 1976; van den Heuvel 1983). ...

... Fitting the observed dependence includes calculations of the polarization cross-sections averaged over particles orientation and size distribution, their normalization and the comparison of obtained dependencies with Serkowski's curve representing observational data for a chosen star. ... Variations of the polarization factors with wavelength are shown in Fig. 16 for homogeneous spheroidal particles with PF orientation. ... The distinction between prolate and oblate spheroids is also clearly seen. ...

Next: Simulated Results with Up: Assessment of Methods Used Previous: Introduction . ... Then one has to use regularized inversion methods in order to obtain approximate and sensible solutions. ... All these methods contain a free parameter which is the so-called regularization parameter; in the case of method ( ) this is a smoothing of the higher spatial frequencies; for the methods ( ) - ( ), it is the number of iterations. ... In the case of method ( ) the iteration scheme is given by . ...