WFC3 Instrument Handbook for Cycle 24 . ... Wide Field Camera 3 Instrument Handbook for Cycle 24 > Chapter 2: WFC3 Instrument Description > 2.3 Spectral Elements . ... 2.3.1 The Filter Selection Process . ... Both WFC3 channels are equipped with a broad selection of spectral elements. ... The UVIS channel has a selectable optical filter assembly (SOFA) that contains a stack of 12 filter wheels housing a total of 48 elements: 42 full-frame filters, 5 quad filters, and 1 UV grism. ...

... Alternatively, the PI channel boundaries will be read directly from the data subspace extension of the input image (not yet implemented). ... EPIC PN offset columns (as specified in the offsets extension of the photon event list) are set to zero in the exposure map, if they had been removed from the input reference EPIC image. ... The task tries to determine the exposure time by looking for gti extensions in the input image of the form STDGTInn, STDGTIn, STDGT, or GTI. ...

The following papers summarize the characterization and technical performance of IBIS : . ... Characterization of Fabry-Perot interferometers and multi-etalon transmission profiles. ... Righini, A., Cavallini, F., Reardon, K. P., 2010, Astronomy and Astrophysics , 515 , A85, . ... The filter wheel is located between the two interferometers. ... The interferometers can be rapidly tuned, simultaneously, so to allow sequential scanning of the spectral lines of interest (see movie in IBIS Intro ). ...

SHORT DESCRIPTIONS OF INSTRUMENTS . ... Particle detector RIEP-2802 was developed and built in Russia. ... The combined Soviet-French ONCH-TBF onboard instrument had in memory modes the data only from several filter-banks in the range from 10 Hz to 16 kHz (while in the real-time telemetry modes, the measurements included 5-component wave-form data in the range 10 Hz - 1.5 kHz for 3 magnetic and 2 electric field components, or a wide-band mode in the range 10 Hz - 15 kHz, and several filter banks). ...

... SPIcam is a general purpose, visible-wavelength, direct imaging CCD camera with > 50% QE between 400-900 nm. It may be operated in either traditional point-and-stare mode or in a drift-scanning mode. The detector in SPIcam is a backside-illuminated SITe TK2048E 2048x2048 pixel CCD with 24 micron pixels and an unbinned plate scale of 0.14 arc seconds per pixel, giving a field of view of 4.78 arc minutes. ... CCD pixel size = 24 m . ... CCD read noise = 5.7 e - / pixel 0.1 . ...

RTT150 . Russian-Turkish 1.5-m Telescope . ... Until 2002 observations were mostly performed with ST-8E CCD in the 1:7.7 Cassegrain focus. ... In April, 2003 telescope was equipped with a larger-size CCD Andor DW436 . ... 2048 x 2048 pixels, . ... Since summer of 2002 the main focal detector of the RTT150 telescope was AP47p CCD in 1:7.7 Cassegrain focus. ... During September 3-13, 2002 works on installation of new autoguiding system ( photo 1 ) were carried out on RTT150 telescope. ...

... Meade Series 4000 Nebular Filters incorporate the very latest in interference coatings technology. ... Technical Basis of the Meade Broadband Nebular Filter: As shown in the transmission graph below, the Meade Broadband Nebular Filter strongly rejects the light of sodium- and mercury-vapor lights as well as natural airglow and auroral emissions. ... Meade Series 4000 Narrowband Nebular Filters . ... Meade Series 4000 Oxygen-III Nebular Filters . ... Meade Series 4000 Photo-Visual Color Filters . ...

RSAA Home . GSAOI Home . ... Other Links . ... Control Software Links . Optics Links . Micro-Optics Links . ... Optical Materials Databases . ... Rockwell Science Center home page . ... Santa Barbara Research Center home page . ... CCD-World home page . ... SDSU home page . ... EPICS home page . ... Optics Society of America . SPIE - Society for Optical Engineering . ... ZEMAX software (Focus Software page) . OPTICAD software (Focus Software page) . ... RedHat home page . ...

... Parameters . Filters . ... Direct images . ... The SCORPIO-2 project: . Spectral Camera with Optical Reducer for Photometric and Interferometric Observations - 2 . The broad-band glass filters made in SAO RAS are used for the observation in the Johnson-Cousins (UBVRI) photometric system in the direct images mode. The glass filters transmission curves are shown by solid line. ... The filters transmission curves of the `comets' filters measured with the SCORPIO-2 in the F/4 beam. ...

... Instruments are more complicated than star catalogs, but a MIDAS table file is still useful for holding the description of an instrument. ... The main sub-table contains information about the passbands used, and the second sub-table describes the detector(s). ... Basic data for an instrument file include the passbands used (and any coding that is used to represent them in the data); the detectors used, and their properties; and general information about temperature control and optical cleanliness. ...

... example, note below the dramatic speedup in searching a 1 Gb file using an AND filter, even when one of the columns (pha) has no index : time fundisp \ huge.fits'[idx_activate=0,idx_debug=1,pha= 2348 4000 4000 1]' \ x y pha x y pha ---------- ----------- ---------- 3999.48 4000.47 2348 3999.48 4000.47 2348 3999.48 4000.47 2348 3999.48 4000.47 2348 3999.48 4000.47 2348 ... Currently, indexed filtering only works with FITS binary tables and raw event files. ...

hstpolsim -- Produce simulated polarization input data frames for HST instruments . ... inint = "" [name] . ... Name of the HST instrument for which simulated polarization images are to be produced. ... Name of the instrument specific polarizing filter for simulated images (ignored for SPECIAL instrument). filtname = "" [name] . Name of the instrument specific colour filter for simulated images. ... The header parameter FILTER provides the filter name and POLANG the polarizer angle. ...

Section I: Introduction to ALFA and GALFA . Section II: System Description . ... ALFA receives 7 beams, 2 polarizations per beam, each covering 1225-1525 MHz. The 14 IF signals cover nominally the 100 to 400 MHz band. ... A high-resolution, low-bandwidth spectrometer (8K channels covering a 7 MHz bandwidth) . ... Each spectrometer board handles two polarizations from one telescope beam.The baseband signals are to be digitized by four 8-bit ADCs at 100 Msamples/sec. ... Bandwidth: . ...

... Обзор LPR фильтра. Впечатления от наблюдений с LPR фильтром. ... Характеристики цветных фильтров Baader-Planetarium . Мой перевод pdf- файла о фильтрах с сайта Baader-Planetarium (379 кб) . ...

hstpolsim -- Produce simulated polarization input data frames for HST instruments . ... inint = "" [name] . ... Name of the HST instrument for which simulated polarization images are to be produced. ... Name of the instrument specific polarizing filter for simulated images (ignored for SPECIAL instrument). filtname = "" [name] . Name of the instrument specific colour filter for simulated images. ... The header parameter FILTER provides the filter name and POLANG the polarizer angle. ...

splitxyz - filter to divide (x,y,z[, distance ,heading]) data into (x,y,z) track segments . splitxyz [ xyz [ dh ] file ] -C course _ change [ -A azimuth / tolerance ] [ -D minimum _ distance ] [ -F xy _ filter / z _ filter ] [ -G gap _ distance ] [ -H [ nrec ] ] [ -M ] [ -N namestem ] [ -S ] [ -V ] [ -Z ] [ -: ] [ -bi [ s ][ n ] ] [ -bo [ s ] ] ... If xy _ filter is non-zero, the data is first divided into segments and then the x,y values of each segment are filtered separately. ...

... Classes . ... casa . casa::LogSinkInterface . ... LogSinkInterface (const LogFilterInterface &filter) . ... virtual . ... Get given part of the i-th message from the sink. virtual String . ... virtual const LogFilterInterface & casa::LogSinkInterface::filter . ... virtual LogSinkInterface & casa::LogSinkInterface::filter . ... virtual String casa::LogSinkInterface::getLocation . ... virtual String casa::LogSinkInterface::getMessage . ... virtual String casa::LogSinkInterface::getObjectID . ...

... Instrument Description . Software: Version 4.0 . Version 3.0:Complete Documentation . ... ИОНОЗОНД ПАРУС, разработанный в ИЗМИРАН, предназначен для диагностики ионосферы и оперативного прогноза КВ связи. ... Общая структура ИОНОЗОНДА ПАРУС, Технические Характеристики , Конструктивные параметры на настоящий момент соответствуют модификации Комплекса: ВЕРСИЯ 3.0 . ... Там же находится полное описание Комплекса ИОНОЗОНД ПАРУС: ВЕРСИЯ 3.0 . ... 2004 IONOSONDE PARUS ...

... This method is called once when the filter is loaded. ... This method should return a flag word that specifies the filters capabilities. ... With CONVERT_TO_FLOAT, the filter is called with the image data converted to a FloatProcessor (3 times per image for RGB images). ImageJ will lock the image before calling this method and unlock it when the filter is finished. For PlugInFilters specifying the NO_IMAGE_REQUIRED flag and not the DONE flag, run(ip) is called once with the argument null . ...

... 18-Jan-2010 16:46 . ... 22K . ... 39K . ... 38K . ...