... A diagram of the output register of the PlutoCCD CCD is shown in Figure 5-1 and illustrates the setup clock waveform and DC potentials for the last three pixels of the serial shift register (V f ), before it is collected in the Summing Well (V sw ), transferred to the Last Gate (V otg ), and then sampled by the output MOSFET, when the charge is dumped to the output node using the amplifier with a Voltage Reference (V ref ), Reset Gate (V rg ), and output drain (V dd ). ...

Еще в разделе: (Показать все результаты (>1760) - www.sao.ru/ )

• Back-Illumination Paper-CCD Operations
• File Formats Required for Photometry
• Electron bombarded sensors-intro

... FIELD | ... METHOD . ... static int . ... Set this flag to have the ImageProcessor that is passed to the run() method converted to a FloatProcessor. static int . ... Set this flag if the filter wants its run() method to be called for all the slices in a stack. static int . ... Set this flag if the filter does not want its run method called. static int . ... Set this flag if the setup method of the filter should be called again after the calls to the run(ip) have finished. static int . ...

Еще в разделе: (Показать все результаты (>584) - www.astro.louisville.edu/ )

• Convolver (ImageJ API)
• StackLabeler (ImageJ API)
• Rotator (ImageJ API)

Some radio clocks and related timekeeping gear have a pulse-per- second (PPS) signal that can be used to discipline the local clock oscillator to a high degree of precision, typically to the order less than 50 us in time and 0.1 PPM in frequency. ... Either way requires conversion of the PPS signal, usually at TTL levels, to RS232 levels, which can be done using a circuit such as described in the Gadget Box PPS Level Converter and CHU Modem page. ...

Еще в разделе: (Показать все результаты (>1528) - www.sai.msu.su/ )

• KSI/Odetics TPRO/S IRIG Interface
• Austron 2200A/2201A GPS Receivers
• Magnavox MX4200 GPS Receiver

deliver_ephem_to_opus . ... Transfers the specified 11-day PASS ephem to OPUS via the interface . ... TITLE: deliver_ephem_to_opus.py . ... PURPOSE: The tool will transfer the ascii 11-day definitive PASS ephem . from the SPSS/PASS area to the OPUS area via FTP. USAGE: do deliver_ephem_to_opus <asciiephem> . ... 27-May-2003 - Don Chance: modified for python 2.2 compatibility . ... Transfers the PASS ascii 11-day definitive HST ephem from the . SPSS/PASS area to the OPUS area via FTP. ...

Еще в разделе: (Показать все результаты (>15735) - www.stsci.edu/ )

• DD Submission Homepage
• Required Reading
• What overhead is required to change ACS detectors during an observing sequence?

Next: Front Illumination Up: Detection Efficiency Previous: Detection Efficiency . Work at Westinghouse [Peckerar et al] first demonstrated the possibility for enhancing X-ray detection efficiency by utilising deep depletion layers. The depth of a depletion layer varies as . where is the depleting potential, and is the acceptor concentration. The applied potential is limited by the breakdown voltage of the MOS structure, and hence the use of high resistivity silicon (low ) is required. ...

Еще в разделе: (Показать все результаты (>6521) - xmm.vilspa.esa.es/ )

• Back Illumination
• Compliance with the ODF interface control document

NGC OPTICAL SOFTWARE Claudio Cumani NGC Presentation - 2008, July 16 Differences btw IR and OPT detector controllers: intrinsic 2 "Exposure" handling Optical Rigid scheme for exposures (wipe - integrate - ["move charges on detector while integrating"] - read ). Active intervention of the control-server during the exposure is ti ti th th required (application of new voltages in each state). ... Starting an exposure = starting transfer and storage of data. ...

Еще в разделе: (Показать все результаты (>45081) - www.eso.org/ )

• http://www.eso.org/projects/www.eso.org.projects.ngc/Software/2003_12_10-Stegmeier-IRACEandNGC.pdf
• http://www.eso.org/projects/www.eso.org.projects.ngc/Software/2005_06_10-Stegmeier-NGCSW.pdf
• http://www.eso.org/projects/www.eso.org.projects.ngc/Hardware/ESOs_Next_Generation_Controller.pdf

... The routine processing of STIS data in the calibration ``pipeline" requires an interrelated set of software tasks and databases developed and maintained by many groups at STScI. We present the systems-level design of this calibration pipeline from the perspective of the STIS instrument group at STScI. We describe the multiple interfaces to the pipeline processes that the STIS group works across in an effort to provide for the routine calibration of STIS data. ... For example, the STIS group: . ...

Еще в разделе: (Показать все результаты (>1791) - www.adass.org/ )

• The Chandra Automatic Processing/Archive Interface
• ADASS 2003 Conference Proceedings
• IMAGER: A Parallel Interface to Spectral Line Processing

... You are here: start €Ё correlator €Ё globus . ... Globus GridFTP . ... Installing GridFTP . ... The 'latest-stable' installer linked from the page above actually installs a rather old version of GridFTP, so you may wish to download a more recent version from here: http://www.globus.org/ftppub/ . ... For source installations, check that the /path/to/install/to/setup/globus/setup-globus-gridftp-sshftp command worked. correlator/globus.txt €§ Last modified: 2016/04/05 18:53 by cormac . ...

Еще в разделе: (Показать все результаты (>19201) - www.atnf.csiro.au/ )

• User interface
• The ATNF Electronics Group : Correlator Interfaces
• Graphical User Interface Example

.

Еще в разделе: (Показать все результаты (>352) - zebu.uoregon.edu/ )

• Astronomy HyperText Book: Fusion Sequences in Stars

The PROS distribution files are stored under an anonftp subdirectory at SAO. ... NOTE: All of the non-tar files (CHECKSUMS, FILES, etc) are ASCII. ... CHECKSUMS . FILES proscal_gen.tar.gz (calibration data, 8.8 Mb, compressed) ./proscal . ... FILES . ... The data (xcalr/xcale) files are in machine-dependent SUN format whereas the FITS (xrcalfits/xecalfits) files are in machine independent format. xcalr_sos_gen.tar.gz (rosat prf calibration data, 23.6 Mb, compressed) ./xray/caldata/rosat . ...

Еще в разделе: (Показать все результаты (>1684) - hea-www.harvard.edu/ )

• Astro::FITS::CFITSIO
• SAOtng Memory Considerations

... Start LonMaker 3. ... Drag devices from stencil to drawing. ... If remote alarm delivery is required, drag the LNS Network Interface functional block from the stencil to the drawing. ... For each device that must deliver alarms, bind msg_remote on the device to msg_in on the LNS Network Interface functional block. ... Select "LonMaker -Network Properties", click on the "Network Interface" tab, check the "Network Attached" box, select the appropriate network interface name and click "Apply". ...

Еще в разделе: (Показать все результаты (>4035) - www.naic.edu/ )

• Arecibo Glossary
• Outline of the Survey Planning Process (requires investment of
• Installing the Kernel Interface

Azimuth Drive Box Replacement . ... A. Start with drive box with soft spring preload Drive #2 . ... Loosen horizontal foot . ... Loosen horizontal foot the remaining amount , push preload foot in to ring and work drive box away from disc. Once clear of disc raise hoist and remove drive box . ... Lift new box in place - do not contact drive disc with box . ... Connect tangential link and set alignment using drive box to disc clearance and foot centering as metrics . ... Repeat for each box. ...

Еще в разделе: (Показать все результаты (>529) - www.apo.nmsu.edu/ )

• Appendix
• PVCam Gotchas
• Procedure to Install the 2.5m Secondary Truss

Flexible frame grabbing to PC over PCI bus from area & line scan cameras . ... Analog input up to 20 MHz and digital input up to 32 Mbytes/Sec. ... The LPG-132 will easily interface to virtually any analog or digital camera and provides lightning fast PCI transfers at an amazingly attractive price. The LPG-132 will interface with any camera or sensor at data rates up to 32 Mbytes/Sec. ... The LPG-132 comes in two configurations - one for analog input and the other for digital inputs. ...

Еще в разделе: (Показать все результаты (>39) - vega.inp.nsk.su/ )

. February 17, 2005. Baikonur Cosmodrome. Assembly-and-test building on site 254 of the Cosmodrome was used to open docking interface of Instrument Compartment, assemble service lines of Soyuz TMA-6 spacecraft and ground network, as well as carry out the required scope of checks. Official WEB-site of S.P.Korolev RSC Energia . E-mail: mail@rsce.ru .

Еще в разделе: (Показать все результаты (>1888) - www.energia.ru/ )

Routines can now be called with keyword arguments and can use default arguments, that means that some arguments can be given with keywords instead of position and some do not have to be given at all, in which case a standard or default value is used. ... IMPLICIT NONE INTERFACE SUBROUTINE SOLVE (A, B, N) INTEGER, INTENT (IN) : : N REAL, INTENT(OUT) : : A REAL, INTENT(IN), OPTIONAL : : B END SUBROUTINE SOLVE END INTERFACE REAL X ! ... You will use keyword arguments and default arguments so that . ...

Еще в разделе: (Показать все результаты (>2054) - crydee.sai.msu.ru/ )

• XFree86/OS2 Download Page
• Hardware and Software Requirements
• XFree86/OS2 Available Ported Software - Tools

The HyperNews Linux KHG Discussion Pages . Forum: The Linux Kernel Hackers' Guide . Re : Kernel source code ( Gabor J.Toth ) . ... Gabor J.Toth ) . ... I didn't respond because I wanted to think about how it could be done, and done in such a way that it would actually be helpful.. I just saw a pointer to cxref posted to comp.os.linux.announce. I don't think that we would have to use its extra documentation features to use its cross-referencing features. ...

Еще в разделе: (Показать все результаты (>8341) - www.arcetri.astro.it/ )

• LASG - Network services - Tftp
• LASG - Network services - DNS
• mod_proxy_ftp - Apache HTTP Server

... Bojan Nikolic web pages (r. 329) . ... http://carma.astro.umd.edu/wiki/index.php/Installing_Developer_CASA . Building CCMTools as required by CASA . ... Building . ... Notes related to building CASA . A prototype build system for CASA using SCons . ... Generating IDL files . ... Notes on the classic CASA build . ... Writing the tool XML file . ... Automatically generated IDL files from the files describing each of the tools of CASA. ... Building CASA . ... Building the casa-core libraries . ...

Еще в разделе: (Показать все результаты (>2972) - www.mrao.cam.ac.uk/ )

• Building CCMTools as required by CASA Bojan Nikolic web pages (r. 329)
• ALMA-related software engineering topics Bojan Nikolic web pages (r. 329)
• AAVP 2010

. Finding The Right Window . "All Windows Are Not Made Equal." . Previous . Main . Next .

Еще в разделе: (Показать все результаты (>1741) - star.arm.ac.uk/ )

• Terry Mosely's Bulletins
• NUCLEAR EXPLOSIVE
• Conference 98

spectrum1d - compute auto- [and cross- ] spectra from one [or two] timeseries. spectrum1d [ x [ y ] file ] -S segment _ size ] [ -C ] [ -D dt ] [ -N name _ stem ] [ -V ] [ -W ] [ -bi [ s ][ n ] ] [ -bo [ s ] ] spectrum1d reads X [and Y] values from the first [and second] columns on standard input [or x [ y ] file ]. ... Units same as ypower. name _ stem .npower Power spectral density of the noise output. Units same as ypower. name _ stem .gain Gain spectrum, or modulus of the transfer function. ...

Еще в разделе: (Показать все результаты (>315) - xray.sai.msu.ru/ )

• http://xray.sai.msu.ru/~ivan/gmt/man/trend1d.html

T he Siding Spring Survey (SSS) is a Near-Earth Object search program that utilises the 0.5-m Uppsala Schmidt Telescope at Siding Spring Observatory, N.S.W., Australia. ... The mission of the Siding Spring Survey is to contribute to the inventory of near-earth objects (NEOs), or more specifically, the potentially hazardous asteroids (PHAs) and comets (PHOs) that may pose a threat of impact and thus harm to civilization. ... Based on the CSS Mission page . ... Siding Spring Survey Main Page . ...

Еще в разделе: (Показать все результаты (>467) - www.mso.anu.edu.au/ )

• GSAOI Orion Nebula Cluster Science Page
• Gemini Near-Infrared Integral-Field Spectrograph (NIFS) IFU.
• Context