1. Choice of array, which is more sensitive to anisotropy

The most simple example of non-linear array is dipole equatorial (D) array. In attempt to connect advantages D (T) and Schlumberger arrays and simultaneously to overcome their lacks the generalized Y-array was invented (fig.2). As T - array it has two MN lines with one common M electrode. These two MN lines go under equal angles from M electrode position symmetrically from AM direction. But this array has one important feature - two MN lines can influence at level of signal while the radiuses' difference (between A and M, A and N), and on sensitivity to an anisotropy depends on angle between AM and AN azimuths. Really, by joining two MN "wings" we receive low sensitive pole-dipole array, and by flinging them we receive T-array, which is more sensitive. It can be shown with the help of spectra (fig.1). But it has appeared, that the wings can be bent in additional area (fig.2), and in this case sensitivity to an anisotropy continues to grow. On this way an arrow-type array (AT) was revealed. Except higher sensitivity to an anisotropy, it has some interesting and useful properties.
1. It was proved theoretically that the signals in both MN lines of arrow-type array above anisotropic media are completely identical. For T and Y arrays it is not so. This property above anisotropic media allows to measure signal only in one MN line. The measurements in two MN lines help to distinguish inhomogeneous medium from anisotropic one by taking into account the difference of two signals.

2. The spectrum of arrow-type array appears very narrow, the harmonics after fourth one can be neglected, and consequently for azimuthal survey the step in 45° is sufficient. The step size is similar to linear array, but sensitivity is higher, than for dipole array (fig.1.). That is because two MN lines are at azimuths with 90° difference. The periodicity of the second harmonic is 180°, i.e. its amplitude for the given array will be maximal, whereas the periodicity of the fourth harmonic is 90° and its amplitude for the given array will be equal to zero. Fourth, eight and some other harmonics are exactly equal to zero, when the radiuses AM and AN are identical. But the possibility of apparent resistivity calculation in this case disappears. If we make these distances different, the fourth harmonic will not be zero, though also small. Arrow-type array is rather convenient for field survey. The scheme of electrodes positions for an azimuth step in 30° is shown in fig.3.
 

V.A. Shevnin, I.N. Modin
Tel. & fax: (7-095) 939 49 63
E-mail: sh@geophys.geol.msu.ru

Please feel free to send us your comments.