[Comphep-common] comphep error

[Ijaz Ahmed]

Hi..
Thanks for reply,
I took from the main webpage of comphep below:
http://comphep.sinp.msu.ru/extra/main
Please would you like to help me, how can i get cross-section values for a energy center of mass energy ranges?
thanks
ijaz
________________________________________
From: Lev Dudko [dudko at fnal.gov]
Sent: 20 November 2014 21:32
To: Ijaz Ahmed
Cc: comphep-common at theory.sinp.msu.ru
Subject: Re: [Comphep-common] comphep error

    Dear Ijaz,
 there are no such script cs_energy_dep.pl in CompHEP distribution.
Where did you take it? Would you like to share it in CompHEP community?

   In batch.dat file you can keep only one energy for each subprocess in
the same time.
     Best regards,
        Lev



В Вс, 16/11/2014 в 06:19 +0000, Ijaz Ahmed пишет:
> Hi...
> i am using script "./cs_energy_dep.pl" in order to produce the plot
> between Ecms and cross-section of my working channel, but i am not
> able to do it. I want to ask, is this script still valid to use it?.
> actually when i run this script with the following way:
> " ./cs_energy_dep.pl 1000 1500 2000" . I created "batch.dat" file by
> using the following command: "./num_batch.pl -run vegas", but i found
> that in the results .ps file there is only one point of Ecms and 1
> point of cross-section. Could you please help me in sorting  out the
> problem.
> thanks
> ijaz
>
>

--
Lev V. Dudko        e-mail:dudko at fnal.gov
t.+41(22)7671498    http://top.sinp.msu.ru